Coloured Wool Serge Acoustic 140cm Wide 465gms - British Made
3 - 5 Days Delivery
Our luxury coloured wool serge fabric is British milled and is of the highest quality. We have secured a supplier that has made this expensive product available for our clients for theartrical work and also we cantreat this fabric for crib 5
100% Pure New Wool
Width 140cm (55”) useable ±2%
Abrasion Resistance 50,000 Martindale Cycles
5 year guarantee of wearability
BS EN 1021.1/2.2006 (Cigarette & Match)
BS5867.2 Type B
Optional treatments required for BS5852 Crib 5
5 (ISO 105-B02:1999)
(dependant on shade)
Fastness to Rubbing
Wet: 4 Dry: 4
(ISO 105 – X12:2002)
Professionally dry clean or wipe clean with a damp cloth
Batch to batch variations in shade may occur within commercial tolerances
|Delivery||3 - 5 Days Delivery|
|Average Roll Size||40 Metres|
|Washing / Cleaning Information Face Fabric||No|
|Flame Retardant Certified Rating||BS5867 Part 2B|
|Pattern Repeat Vertical (cm)||1|
|Fabric Width (cm)||140|
Piece of paper
For recording your
Someone to assist if your
windows are large .
As this will allow you to get a
rigid full length measurement.
The first step is to decide whether you want your curtains to hang from, whether you go for a curtain track or a curtain pole, both of which should be positioned 15cm (6 inches) above the window and extend 15-20cm (6-8 inches) either side.
You want to measure the total width of the track or pole, excluding the finials as these will not be covered. Then add a small amount on to allow for an overlap of your curtains.
When you are ready to measure, you have to make a decision about where you want the curtains to finish. The choices are whether to go to the sill, below the sill or to the floor. We suggest that:
- Sill length curtains finish 1.25cm (1/2 inch) above the sill.
- Curtains that fall below the sill should finish 15cm (6 inches) below or just above the radiator to stop heat loss.
- Floor length curtains finish 1 - 1.5cm (1/2 inch) from the floor (although you can create a shappy sheak look by having them puddled on the floor, but that is personal preference).
It is essential that you double and triple check your measurements as if you have measured incorrectly your curtains will not fit properly and if they are made to measure / custom drapes they cannot be changed.
Measure the exact width of the recess in three places; at the top of the recess, in the centre of the recess and near the bottom - then take the smallest size.
Measure the exact drop of the recess in three places on the left hand side of the recess, in the centre of the recess and on the right hand side of the recess - then take thesmallest size.
We will take one cm (half an inch) off the finished width size you have given us, to allow for the blind to pull up and down easily. The amount of fabric required will be more than this finished size, This is to allow for fabric hemming.
Measure the width of the actual recess plus an additional amount – Usually from 7cm-15cm (3" - 6") whatever you think looks appropriate.
Measure the exact drop of the recess. The blind would be fitted above the recess, so check the space above and add an amount on to the drop – usually from 15-20cm (6" - 8")
These sizes you have taken will be the size of the finished blind. The amount of fabric required will be more than this finished size this is to allow for hemming.