Flame Retardant Blackout Lining 274cm Wide - Ivory
Next Day Expected But Not Guaranteed
This is our premium flame retardant blackout fabric. It is perfect for both domestic and contract. It can be used in all commercial environments and is certified to BS5867 part 2B.
This fabric has a gorgeous weight and would be ideally suited for a super finish in a hotel. Bring any face fabric to life and add a large amount of body.
Please do not be put off that it is a flame retardant lining. The feel of this fabric is simply incredible and will complement all weights of fabric.
3 Pass Blackout
|Delivery||Next Day Expected But Not Guaranteed|
|Average Roll Size||30 Metres|
|Flame Retardant Certified Rating||BS5867 Part 2B|
|Washing / Cleaning Information Face Fabric||30 Degrees (When Blackout Lined), Cool Iron, Non Iron|
|Fabric Width (cm)||274cm|
|Pattern Repeat Vertical (cm)||n/a|
Piece of paper
For recording your
Someone to assist if your
windows are large .
As this will allow you to get a
rigid full length measurement.
The first step is to decide whether you want your curtains to hang from, whether you go for a curtain track or a curtain pole, both of which should be positioned 15cm (6 inches) above the window and extend 15-20cm (6-8 inches) either side.
You want to measure the total width of the track or pole, excluding the finials as these will not be covered. Then add a small amount on to allow for an overlap of your curtains.
When you are ready to measure, you have to make a decision about where you want the curtains to finish. The choices are whether to go to the sill, below the sill or to the floor. We suggest that:
- Sill length curtains finish 1.25cm (1/2 inch) above the sill.
- Curtains that fall below the sill should finish 15cm (6 inches) below or just above the radiator to stop heat loss.
- Floor length curtains finish 1 - 1.5cm (1/2 inch) from the floor (although you can create a shappy sheak look by having them puddled on the floor, but that is personal preference).
It is essential that you double and triple check your measurements as if you have measured incorrectly your curtains will not fit properly and if they are made to measure / custom drapes they cannot be changed.
Measure the exact width of the recess in three places; at the top of the recess, in the centre of the recess and near the bottom - then take the smallest size.
Measure the exact drop of the recess in three places on the left hand side of the recess, in the centre of the recess and on the right hand side of the recess - then take thesmallest size.
We will take one cm (half an inch) off the finished width size you have given us, to allow for the blind to pull up and down easily. The amount of fabric required will be more than this finished size, This is to allow for fabric hemming.
Measure the width of the actual recess plus an additional amount – Usually from 7cm-15cm (3" - 6") whatever you think looks appropriate.
Measure the exact drop of the recess. The blind would be fitted above the recess, so check the space above and add an amount on to the drop – usually from 15-20cm (6" - 8")
These sizes you have taken will be the size of the finished blind. The amount of fabric required will be more than this finished size this is to allow for hemming.